Technical data
230V 1-Phase
Engine data
| Power | 90 W |
| Rotation speed | 1360 RPM |
| Nr. of poles | 4 |
| Rated current | 1,1 A |
| Capacitor | 5 µF |
Other data
| Weight | 4+0,4kg/100mm |
| Max work load | 4000 N |
| Max static load | 5000 N |
| Stroke lengths | 100/200/300/400 & 500mm |
| Safety norm | IP 55 |
| Ambient temp. | -20 to +60 degrees C |
End stops
The actuator is equipped with an end position stop to prevent jamming, for example if the limit states would be crossed or at the adjustment of these.
Ratio
The transmission of power between motor and screw is performed with a synchronous transmission belt. The velocity can be varied with three different ratios;
1:1, 1.8:1 and 3.5:1
Performance and material
The outer tube and gear box is manufactured in anodized aluminum and the nut tube in chromium-plated steel.
Brake
Loads exceeding 500N requires a brake. The brake is an electromagnetic spring pressure brake.
Limit switches
Limit switches is a reed contact type. These are assembled on the actuators outer tube and shall not be used for direct switching of or closing of motor counter flow. For this, use middle circuit breakers.
Intermittency factor
As standard, the actuator is equipped with a starting capacitor of 5uF. The actuator can be operated intermittently at 10% with full load. If the actuator is to be run more often or with many starts, a smaller capacitor is recommended.
400V 3-Phase
Engine data
| Power | 90 W |
| Rotation speed | 1400 RPM |
| Nr. of poles | 4 |
| Rated current | 0,34 A |
Other data
| Weight | 5,8+0,4kg/100mm |
| Max work load | 4000 N |
| Max static load | 5000 N |
| Stroke lengths | 100/200/300/400 & 500mm |
| Safety norm | IP 55 |
| Ambient temp. | -20 to +60 degrees C |
End stops
The actuator is equipped with an end position stop to prevent jamming, for example if the limit states would be crossed or at the adjustment of these.
Ratio
The transmission of power between motor and screw is performed with a synchronous transmission belt. The velocity can be varied with three different ratios;
1:1, 1.8:1 and 3.5:1
Performance and material
The outer tube and gear box is manufactured in anodized aluminum and the nut tube in chromium-plated steel.
Limit switches
Limit switches is a reed contact type. These are assembled on the actuators outer tube and shall not be used for direct switching of or closing of motor counter flow. For this, use middle circuit breakers.
Brake
Loads exceeding 500N requires a brake. The brake is an electromagnetic spring pressure brake.